#2013 chevy volt key fob driver

When all additional transmitters are programmed, press and hold the POWER button for 10 seconds to exit programming mode.

To program additional transmitters, repeat Steps 4 through 6. Remove the transmitter from the transmitter slot and press UNLOCK on the transmitter. When the transmitter is programmed, the DIC will show that it is ready to program the next transmitter.Ħ. Press and hold the POWER button for two seconds. Extend the key blade on the new transmitter and insert the key blade into the transmitter slot.ĥ. Remove the rubber mat in the instrument panel storage. The type of key you had and the year the car was manufactured are the most important factors for identifying if you need a chip, intelligent fob, push to start. The DIC display should now show READY FOR REMOTE #1.Ĥ. Remaining transmitters can be programmed during the next steps. After the third time, all previously known transmitters will no longer work with the vehicle. The DIC display will again show REMOTE LEARN PENDING, PLEASE WAIT.ģ. Wait for 10 minutes until the DIC displays PRESS START BUTTON TO LEARN and then press the POWER button on the center stack.

#2013 chevy volt key fob driver

The Driver Information Center (DIC) displays REMOTE LEARN PENDING, PLEASE WAIT.Ģ. Insert the vehicle key of the transmitter into the key lock cylinder on the outside of the driver door and turn the key to the unlock position five times within 10 seconds. The vehicle must be off and all of the transmitters must be in the vehicle.ġ. If there are no currently recognized transmitters available, follow this procedure to program up to five transmitters.

The Canadian regulations require that Canadian owners see their dealer for programming new transmitters when two recognized transmitters are not available. Programming without a Recognized Transmitte r When the transmitter is programmed, the DIC will show that it is ready to program the next transmitter. Press and hold the POWER button on the center stack for two seconds. Extend the key blade on the new transmitter and insert the key blade into the transmitter slot.Ĥ.

Use this to pry apart the top and bottom halves of the key fob. Now, find a piece of stiff plastic or two that is a little thicker than a guitar pick and a little thinner than a credit card. Remove the rubber mat in the instrument panel storage. Remove the silver key from the end of the fob by pressing the small silver button on the side and pulling the key straight out. The Driver Information Center (DIC) displays READY FOR REMOTE #2, 3, 4 or 5.ģ. Insert the vehicle key of the new transmitter into the key lock cylinder on the outside of the driver door and turn the key to the unlock position five times within 10 seconds. Place the recognized transmitter(s) in the cupholder.Ģ. To program, the vehicle must be off and all of the transmitters, both currently recognized and new, must be in the vehicle.ġ. For vehicles sold in Canada, two recognized transmitters are required to program a new transmitter. Programming with a Recognized TransmitterĪ new transmitter can be programmed to the vehicle when there is one recognized transmitter.